I bought a set of 'Jazz' and 'Fit' ones for $80ish. They have self-adhesive 3M tape on the back of them. Easy as. The wiring is the hardest part, but now that you guys know where it is, its easy as piss!
hey guys, i did the same installation on my jazz. bought the same one MR FIT is talking about, with the fit logo. i actually did a really easy install cos i unscrewed the door senso (on the side) and hooked up the negative to that terminal then hooked up the positive to a constant power from a wire in the fuse box.
if you need a guide, this is how i did mine:
1)take off door seals
2)run wires neatly all so that they endup in the front driver and front passanger sides
3)unscrew the door sensor
4)unplug the cable and tap into it connecting the negative wire of the sills (brown from memory)
5)if you look at the fuse box under the dash, you will find 2 cables attatched to a fuse kind of hanging on a clip to the left of the fuse box.
6)tap into this and connect the positive wires (black i think)
7)test the thing
8)should turn on when door open (mine has an slight annoying beeeeeeeeppppp sound when turned on,that i guess doubles as a door open reminder)
hope that helps=)
Zhen
Unfortunately no pics, but my guide would be very similar to supatts. I bought 6 metres of extra cable (audio cable is fine) and a fuse/fuse holder.
1. unscrew the handle above the drivers door
2. take off door seals and plastic linings
3. Cut the wires (green/red from what i remember) and connect them to the door sill wiring (remember this is with the extra wire for length). you will see the wires you will need to cut comming from the front top running from the windscreen
4. splice the original wire back into the wiring loom so the roof courtesty light also comes on
5. hide all the wiring in the door sill cavities - there is plenty of space just under where the seatbelts roll up (you'll notice theres little black boxes attatched to each door sill - they are transformers and shouldnt take up much space)
6. the sills should be on glowing already as you need the doors open during install so make sure they are constantly on when you do the wiring. Test by closing the doors to make sure it switches off with the roof courtesy light when all doors are closed
7. put all your plastic linings and seals back and screw the handle back up so it looks normal.
8. wait till its night time and enjoy
Bookmarks