Ok I installed the JDM Taillights with the amber blinkers today. It was pretty easy took me just over an hour to install them.
The bumper is held on with 3 screws. 2 in the wheel well and one on the bottome of the bumper connecting it to the back of the wheel well. Last there are two clips in the middle between the exhaust tips.
First screw that need to be removed at top of rear wheel well. One on each side of car.
Second screw that need to be reomved from the lower part of the wheel well. One on each side of car.
Third screw that needs to be removed on lower part of bumper about two inches in from edge of wheel well.
You need to pop of this screw to access the 10mm bolt that is behind it. One on each side.
Then remove this bolt. One on each side
Then remove the two clips on the under side between the exhaust tips. There are two of them.
For those of you that have removed the front bumper the rear bumper snaps off the same way once you have all the screws, bolts, and clips off.
This is what you start with after the bumper is removed.
Once the bumper is off start on one side and remove the 3 8mm bolts holding the taillight on from the inside of the car and then disconnect the cables.
Then remove the two 10mm bolts shown here first. Then pull the taillight out and remove the screw that hold the plate to the light.
After this remove the bulbs from the original light and insert into the jdm light. Then reverse the process to install the new taillight.
Before: with factory tails
After with JDM Tails: You cant really tell that they are different at all when they are off.
Close-Up of JDM Tail: not lit up
Close-Up of JDM Tail: blinker on
Well I hope this is helpful to anyone that attempts to do this.
Bookmarks