EF8/9 Part numbers/Info/Owners Thread

**genkimashi** · 21-07-2008 06:57 PM

Got mine today...vtec solenoid gasket.... have to order it from melbourne apparently as not lots of honda part dealership keep hold of it... n thx for the guide... PR3 the way to go...

**gnx1987** · 25-07-2008 04:53 PM

Has anyone needed to fix the y1 gearbox? Mine doesn't want to hold 5th gear anymore. I can engage but once I take the clutch out it pops out.

**ToOLx** · 30-09-2008 09:06 AM

Looking for the part number or where to find the below:

Y1 Gearbox Oil Filler Bolt

Thanks

**Dxs** · 02-10-2008 03:32 PM

i would say any b series filler bolt will fit

**ToOLx** · 14-10-2008 08:03 AM

With reference to the question I asked above, after doing some research discovered the below:

Honda 92800-20000 (Bolt, Drain plug 20mm) (FILL PLUG)
Honda 94109-20000 (Washer, Drain Plug 20mm) (FILL PLUG)
Honda 94109-14000 (Washer, Drain Plug 14mm) (DRAIN PLUG)

Honda 54110-SH3-003 (Change Lever Ball Seat)
Number 9 in diagram

Honda 54115-SH3-000 (Change Lever Dust Seal B)
Number 13 in diagram

Honda 54111-SH3-000 (Change Ball Holder)
Number 10 in diagram

Honda 46505-SA5-000 (Pedal Stopper Pad)
Rubber piece that turns off brake lights by resting against the switch.

Found these off a honda parts website, then enquired with torque honda part's desk to confirm with my EF9, placed the order and now waiting for them to come in from Japan/Melbourne. Refurbing a few old bit's and pieces, as the gear stick rubber seals/holders seem to have worn out over the last 17 years. Getting it all back to OEM freshness.

**Bludger** · 15-09-2009 06:49 PM

ef8 engine mounts???

the one of the front of the car, next to the radiator?

I wasted $60 at autobarn for the wrong mount.

can't return it cos its special order

can someone help me out?

I hear that da teg parts are samish??

I just need that mount on the side of the engine/front of the car.......

Bau

**Fergs** · 17-09-2009 03:20 PM

Hey Bludger try this site - from pic you need a 50840-SK7-01

http://www.crxsi.com/jdm/

all the part number we will ever need - I did all my mounts from this site and were all spot on - even got the honda dealer to check vin against the numbers i had found and all was good