Injectors

[DR1600]

Hey guys what would be the best upgraded injectors to get for my mates civic if he is going to turbo it, the engine is a D16Y4, and where would he get them from.
Thanx.

[jimmeh]

have a look at this
http://www.rceng.com/technical.htm

[SKREMN]

depend what setup his going how big a turbo ect
he will have to upgrade them
i'm running 500cc MSD in my B20 N/A

[tinkerbell]

DR1600 - depends how much poower the guy wants to make...

SKREMN - those injectors are wayyyyy to big, are you runing less than 30psi fuel pressure or what?

[ProECU]

why are those injectors "wayyyyy" to big? please elaborate.

[SKREMN]

i am running stock fuel pump and and 38 psi
the pump is holding up fine and holding a good air/fuel ratio

[tinkerbell]

i am running stock fuel pump and and 38 psi
the pump is holding up fine and holding a good air/fuel ratio

what are you tuning with? can it tell you the duty cycle?

[Posty86]

DR1600's mates turbo is a t3 with enlarged exhaust housing

[saxman]

they may not be "wwwayyyy" too big, but they're probably quite a bit larger than needed

[SKREMN]

what are you tuning with? can it tell you the duty cycle?

Just using hondata s100

[superR]

bloody datto drivers! lol
hey man i highly recomend the rc440 or550 depending on the rest of his set up.
as jimmeh said go to http://www.rceng.com/.
im pretty sure he can supply you with them too.

james

p.s datto's are made of sheet metal! lol

[DR1600]

bloody datto drivers! lol
hey man i highly recomend the rc440 or550 depending on the rest of his set up.
as jimmeh said go to http://www.rceng.com/.
im pretty sure he can supply you with them too.

james

p.s datto's are made of sheet metal! lol

lol be careful what you say cause you won't be laughin when i'm looking at you in my rear vision mirror hehe honda boy

P.S. thanx for the info.