Honda S2000 Body kits

[Geordie]

I am currently contemplating whether or not to put a body kit on to my S2000, front, back and sides.
A smash repairers called Nutec in Yennora NSW have quoted to supply, fit and paint the kit at a cost of $1500-$1600 seems like a good buy at that price. I have attached a pic of the kit.
My questions are as follows,
Has anyone dealt with Nutec before ?
Do you think the price quoted is a good price?
Has anyone had a similar kit fitted and what problems have you had post fitting.
Lastly the question I might not want to hear the answer to, Is it wanky to do this to the S2K?

Geordie or

[IRI]

No, definantly not to body kit, especially that one...

Why destroy Honda's good work?

[ludecrs]

You can kit the S, and make it look decent, but that kit...... no thank you.

[WhiteAP1]

Please dont do that to ure car

[Vuey]

seriously , that bodykit does not suit the smooth lines of the S2000 .

For that price, im sure it is made from fiber glass, one nudge and you'll be up for a new front bar , sides etc. And fit gets worst with time.

If you must kit your car, spent abit more $$$ and get a decent looking kit .

[chicken8]

as the S2000 gets cheaper. more and more ricers will start buying them

then its fast and furious all over again

[aus91integra]

oem lip kit is all you would need.. its already a nice looking car..

[[stealth]]

do it mate ahhaa

[MRSPCS]

^^ yeh do it dude, so i can have a laugh

[.::F[L]Y::.]

you think thats bad....theres an s2000 going around western sydney (liverpool) with a 2 tone paint job. front half is GPW and back half is burgundy....it has what appears to be a veilside front bar or whole kit. and to top it off has some chromes....worse s2k i have seen....

[jonni3e]

I think it looks wrong.
I think you should go for an OEM AP1 kit, or do a AP2 front end conversion with AP2 OEM front lip or get the amuse r1 front bumper. Those are clean.

[Geordie]

Muchas Gracias,,,Great feedback to date, back of my mind says No also, I have seen a few S2k's around with kits and they look fantastic, probably people of this board in Sydney. I dont want the boy racer appeal as I am an old bastard,and don't want to ruin the beast, just enhance it as it is a hobby as well as a ride, I will check out jonni3e's suggestions, but any other feedback on suppliers, fitters, and body kits etc in Sydney would be greatly appreciated, sorry guys I am a novice at this, just found the board and lovin it, and lovin my S2000, although not in the biblical sense, ha ha

Geordie