Page 1 of 2 12 LastLast
Results 1 to 12 of 13

Thread: EF8 PARTS

  1. #1
    Hi guys, dose anyone know where i can get some cheap dash parts for a ef8 crx
    I got a half cut and i am missing a few bits.
    :cry:

  2. #2
    Member Array
    Join Date
    Sep 2003
    Location
    Pyrmont, NSW
    Car:
    Red Rocket SSV
    I also got an ef8 half cut sitting in pieces ... what dash parts do you need bud ?

    Steve-O

  3. #3
    Needs more time... Array
    Join Date
    Aug 2003
    Location
    Sydney
    Blog Entries
    12
    Have a look at the sticky in the Marketplace forum. There are some Honda parts dealers listed there.

    Gluck.
    Got a question? Check out the FAQ - http://www.ozhonda.com/go/faq

  4. #4
    '99 DC2R/'88 CRX Array
    Join Date
    Sep 2003
    Car:
    DC2R/CRX
    Steve-o is highly recommended.

    The EF8 airbox works a treat in my EF9
    '99 DC2R, '90 BMW E30 318is, '88 CRX


  5. #5
    Member Array
    Join Date
    Sep 2003
    Location
    Pyrmont, NSW
    Car:
    Red Rocket SSV
    good to hear bud

    engine should be getting put in next week so will let U know about the mounts then man.

    as for the dash ... I got complete dash but in pieces.

    only prob is the a/c section is broken

  6. #6
    My a/c is broken in two aswell.
    I am after a complete a/c.
    and the main cd ashtray and storage section.
    Mine was brocken at the base of the tape slot.
    Do you know where you can get panell replacement filters, i went to honda and they dont know what an ef8 crx is. or the filter elemant....

  7. #7
    '99 DC2R/'88 CRX Array
    Join Date
    Sep 2003
    Car:
    DC2R/CRX
    I have two - one was made by Jamex (it's for the euro EE8/EE9) and the other was custom made by Finer Filter (they are around the corner from me at Rydalmere). The custom made one is excellent - it cost me 50 bucks and can be cleaned with dishwashing detergent and re-oiled using finer filter's "oil". The jamex looks nicer, but I'm not sure that it flows as well as the FF - but Gary from the NSW HCC had it on hand.

    Looking at them, I'd go the FF route personally

    BTW guys, re the A/C - unlike the Aussie ones, they are servo operated and you cant get the parts from Honda Au (hereafter known as the "bastards") as they will not look for parts for anything that wasn't released in Australia. Honda NZ on the other hand will and Strong for Honda (wreckers) is your best bet for excellent service and parts availability

    Cheers
    '99 DC2R, '90 BMW E30 318is, '88 CRX


  8. #8
    Thanks for your help mate, I have to go to rydalmere today so i might check them out.
    Ill get in contact with honda nz, tanks again.

  9. #9
    '99 DC2R/'88 CRX Array
    Join Date
    Sep 2003
    Car:
    DC2R/CRX
    No worries - if you are out Rydalmere way, give me a ring on 0423223852 and you can see what mine looks like.

    Cheers
    Pete
    '99 DC2R, '90 BMW E30 318is, '88 CRX


  10. #10
    I just got back and seen the message but i might be out that way in the next couple of days so i might give you a call.
    cheers

  11. #11
    '99 DC2R/'88 CRX Array
    Join Date
    Sep 2003
    Car:
    DC2R/CRX
    No worries mate
    '99 DC2R, '90 BMW E30 318is, '88 CRX


  12. #12
    Member Array
    Join Date
    Sep 2003
    Location
    Pyrmont, NSW
    Car:
    Red Rocket SSV
    are you after the centre piece that the stereo headunit slides in between and theres a small shelf under it and then the ashtrey under that ?

    I might have that piece in my garage at the other house ... I will go down and check sometime this week for U.

    I know I got the ashtrey sitting there ... but I think some parts fell off the truck on the way to the house from the workshop lol

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.