So I cant buy EK Hatch Coil overs and install into my EG hatch is that correct because I need to change the rear lower arms but the fronts will fit correct ?
fronts should bolt up
you can't switch lca's between ek's and eg's(ek's are longer than eg's) but you can modify the bushing to fit
i haven't checked the dimensions before but i suspected if you picked up a replacement bush for an ek you might be able to press it into the stock eg lca so you don't have to shave down the bush
eg6/itr are a different ballgame though being eyelet's instead of forks
im about to pick up eg king spring's super lows tomorrow morning and will be putting them on my ek hatch (using stock ek shocks). Am I going to have any trouble's?
im about to pick up eg king spring's super lows tomorrow morning and will be putting them on my ek hatch (using stock ek shocks). Am I going to have any trouble's?
Itll just sack like a mofo cos EK is heavier than EG. Equivalent to EK ultralows
KEEP IT VIET | KEEP IT JDM
FaLL iN LoVe WheN YoU aRe ReAdY, NoT WhEN YoU ARe LOnEly
thanks for informing me, was a little worried there would be a problem since eg is a fairly smaller vehicle but the only problems ive found in research is the eg / ek rear shocks dont co-opperate.
i might sound noobish but even with gaurds rolled will i still get scrub problems with eg king springs in the ek on a daily drive, or will scrubbing only occur with full load or hard cornering
Bookmarks