Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Lift your stock wing up a bit
Required: spacers/nuts/gromets
Steps:
-Remove your stock EK wing by removing the plastic under the boot then the 4 screws
-Then lift up the wing and add your spacers/nuts/gromets what ever you prefer to use on the outer stud (closer to brake light) now use the nut from the wing and bolt it on the same stud you put them spacers/nuts/gromets on.
-Now bolt the wing back on and its lifted :P
Other comments
Make sure when bolting back on the 2 nuts on the studs, it covers and sits flush on the hole to prevent water leaking in.
BEFORE:
AFTER:
YES I KNOW ITS POINTLESS TO SOME PEOPLE. I THOUGHT ID SHARE
AND YES THIS WOULD WORK ON A SPOON REP WING
For EK9 Wing refer to this DIY I have made.
http://www.ozhonda.com/forum/showthr...9-Wing-lifters
Bookmarks