Prelude Question

[Jnr Teggy]

i think its quicker now than when i raced him..

tidy conversion except for the sump ground clearance

[LUD02C]

Sam, went i went to the runs with him (last sunday) he raced a 180SX...
And he kept side by side with it....

The 180SX could of been playing i don't know!

[Jnr Teggy]

The 180SX could of been playing i don't know!

or driving like a monkey!


lol...std 180's arent that fast mate

[Calvo]

but 180's do go pretty hard, well the SR20DET models. this guy mighta had a CA18DET model

[LUD02C]

Sam u probably know him!
number plate own it (not spelt that way)

[Jnr Teggy]

i think they are only good for a mid to low 15 out of the box...

correct me if i am wrong...


and feildings should be good for a low to flat 15...maybe even a 14 with slicks and a good launch!

[Jnr Teggy]

Sam u probably know him!
number plate own it (not spelt that way)

its the baby blue metallic one with BSA mags

[LUD02C]

Nar, Sam it's white, always on the Cruise's with TommO and Dremen and them!

[Calvo]

ohh is this the dude with the H22A lude? yeh that would go pretty damn hard.
my bad

[Tessai]

I got quoted $4500 for half cut and install on a H22 into my 92 Prelude S in Adelaide.

Half cut alone cost $3200, dont know how u can get a H22A half for $1200?! Vtec stuff aint cheap.

As for installation costs, the guys from www.honda-tech.com in the US said it was a direct swap so no custom anything, cos they use pretty much a lot of the same stuff, wish i knew how to do it myself........

[Jnr Teggy]

Nar, Sam it's white, always on the Cruise's with TommO and Dremen and them!

hmmm haven't seen this one...

wouldn't mind a looksee or even a run with him..


i should arrange a dual H22 run with my mates!

[Calvo]

yeh ive been told wirin harness etc is all pretty much straight swap.
but i aint jokin man, i saw the half cut at jap wreckers site for $1250!! thats includin delivery. so install tho.
ill see if i can dig it up again.