EP3 Type R

[butterfingers]

They're 64.1 mm

[UNA91]

They're 64.1 mm

From what i've read that is for the FL models, the Pre FLs are 56.1, can someone confirm?

[-JC-]

Has anyone had any experience with OBD2 senders and EP3s? I am looking at this one http://www.ebay.com.au/itm/140833529...ht_1968wt_1144 but I'm not sure if it's going to play nice with the EP3.

Does anyone know which OBD protocol these things employ or had any experience with the device in question?

[UNA91]

Has anyone had any experience with OBD2 senders and EP3s? I am looking at this one http://www.ebay.com.au/itm/140833529...ht_1968wt_1144 but I'm not sure if it's going to play nice with the EP3.

Does anyone know which OBD protocol these things employ or had any experience with the device in question?

Lol I actaully got one this week cause I was curious, and well it wasn't too expensive anyway. My verdict, it does work; but not very well. The best app out there for these scantool things is called "Torque". With the cheap ebay one I got, I can only get it to read my speed, coolant temp, throttle position, RPM and volts, and a few other not so important functions like trip km etc... All the other functions like oil temp, EGT and other goodies won't work. Haven't really used the scan code function since i've got no codes to scan anyway tho.

[Symphorced]

Got that same one. Good to check for error codes if you start throwing a CEL and agreed on Torque being the best app. Standard version is free too.

[SuperSteve]

Just installed my Haltech and again!!!

Man did I forget how my more power it has....

Wicked

Hehe I'm loving my haltech even more after getting new rubbers. That pull !

[Lukezen27]

Hehe I'm loving my haltech even more after getting new rubbers. That pull !

Think its time for the 1/4 mile again but I've got cheap rubber

[Perry]

Hehe I'm loving my haltech even more after getting new rubbers. That pull !

The hoon king has spoken.

[SuperSteve]

Think its time for the 1/4 mile again but I've got cheap rubber

If u go let me know I'm hoping ill crack 13s

[SuperSteve]

The hoon king has spoken.

I would never pass the legendary Perry !

[Perry]

I would never pass the legendary Perry !

LEgendary cxi.boy =)

[UNA91]

I'm looking at the the Buddy Club Pro Spec exhausts, and just wondering what the difference between the Spec I, II, III, IV is... From what i've read the Spec I is for US designed Hondas; does that mean it won't bolt straight on to the JDM EP3?