EP3 Type R

[Symphorced]

hey bro did you get around to installing a double din yet? trying to find a harness

Yep all installed. No harness required for my install because previous owner had done all the hard work with the wiring already. All I had to do was colour match and crimp.

Still have to wire up the reverse camera and finish up my gauges though. Still haven't found a gauge holder I'm fond of..

[greenek]

:3 lol

[UNA91]

Man whats everyone paying for fuel? here in brisbane its at a record highest at $1.66/L for 91 octane. $1.77 for 98. Apparently predicted to rise...

[Vvvtec]

will be $2 soon

[DreadAngel]

ECU tuning making more and more sense now...

[u mad?]

before you know it only the rich and wealthy will drive petrol v8 or turbo

na for life (and not buy choice)

[DreadAngel]

before you know it only the rich and wealthy will drive petrol v8 or turbo

small na for life (and not buy choice)

Fixed

[u mad?]

Fixed

yes good point lol

[UNA91]

doesn't help when the au dollar is so damn weak atm too

[UNA91]

Will an exhaust for a usdm ep3 (civic si) fit the jdm ep3? I heard there was some differences?

[doosra]

Will an exhaust for a usdm ep3 (civic si) fit the jdm ep3? I heard there was some differences?

Nope, won't fit.

[UNA91]

ok seriously considering the getting the kpro v3 now, but i won't be able to get a tune until prob next month or so due to other priorities. Would it be safe to run on the closest matching base map (k20a ITR or K20A2 with itr cams and CAI probs) until i get a tune? Probs gonna do a datalog and eliminate as much as the knocking as possible if any and take it easy.

Also, after a tune, should be there any knocking at all? been reading that a little is possible and ok but then also read that any knocking is not acceptable? last thing i'd want is to pay heaps of money just to prematurely destroy my engine lol