Project DC2

**INTEG** · 13-10-2007 12:52 AM

Hi guys, as you know im going force induction way, im ripping out my engine on 19th next week, let me know what you think and any advise? the setup is.

Parts Already got..

T3/T4 turbo iron cast manifold
Oil cooler kit
egale h rods
Bc spec 3 cams
Bc P1 retainers
Bc Cam gears
Bc valve springs
Walbro 255 fuel pump
skunk2 intake manifold
Hasport engine mounts
Aem fuel Rail
Sard Fuel Reg
Cp pistons, Any idea what C/R would be good for my setup?
Rebuild head, Let me know is worth the money to port and polish for force induction?
Rebuild bottom end, Let me know any ideas what i should do with the bottom while im getting it done?
Kaaza LSD Diff 1.5way

When i get it started i will be posting pics up as i go along keep use updated!!!

**SLOWEGG** · 13-10-2007 02:16 AM

Since you're building your motor why dont u invest in a better manifold?

**Sexc86** · 13-10-2007 09:14 AM

dont go a super low compression on your piston. 10:1 Cp forgies would be good!

^ tru me thinks a dc2r intake mani / skunk 2 or edlebrock

**fatboyz39** · 13-10-2007 09:51 AM

Originally Posted by SLOWEGG

Since you're building your motor why dont u invest in a better manifold?

There nothing wrong with them.

**yourfather** · 13-10-2007 09:55 AM

i think he means the exhaust manifold not the intake.

**TheFranchise** · 13-10-2007 10:48 AM

upgrade valve springs also??

**INTEG** · 13-10-2007 07:32 PM

sorry guys i got skunk2 intake manifold i forgot to write it down and for valve spring it came with the BC kit

**INTEG** · 15-10-2007 08:41 PM

[QUOTE=Sexc86;1384928]dont go a super low compression on your piston. 10:1 Cp forgies would be good!

VTIR B18c is already 10:1 ratio welz that what it says in the SnapOn book is rite some corrt mi?

**eg_08_wa** · 16-10-2007 05:25 AM

could u pls pm me wif details of who is doing ur work? looking for good workshop.
cheers

**INTEG** · 16-10-2007 05:59 PM

Originally Posted by eg_08_wa

could u pls pm me wif details of who is doing ur work? looking for good workshop.
cheers

Welz most of the work im doing at my work cause i work for hyundai company, but the block and head work im sending out, im tossing between mod performance in ozpark or Balcatta engine recon for the block work. couple of the guys at my work had stuff done terh and they say they do a really good job. And for the head work Head Torque in ozpark or Balcatta engine recon. i will worry about it on monday cause my engine will be out by then. i will be taking some fotos to post up this friday