b18 question.

[Adoomi]

hey guys i need a little help on this one.! iv got a b18c07 block and i dont have the little screws that go into the cylinder walls of the block iv now just got small holes in each side of the cylinders just would like to know how i would get some of these screws

thanks Adam

[EG5]

you need head bolts?

[Adoomi]

nah dont think so its on the block not the head..the holes r like 2mm thick if that..

[destrukshn]

pics would be very good right now.

[TODA AU]

hey guys i need a little help on this one.! iv got a b18c07 block and i dont have the little screws that go into the cylinder walls of the block iv now just got small holes in each side of the cylinders just would like to know how i would get some of these screws

thanks Adam

Do you mean from the outside of the block, through the water jacket & onto the clyinder sleeve (outer alloy section) ?
These sound like posting screws.
If you just want to block them off, use alloy grub screws.
You may need to tap the tread in the hole to suit if you're unable to find grub screws of the correct thread.
These are available from EARL's in Silverwater.