I thought 96 ITR was 4x114mm PCD.
Civic's have 4x100mm PCD.
The reason the 96 ITR rotors are recommended is that you can re-drill them to 4x100mm without overlapping existing bolt holes.
This preserves the rotor balance.
> would i need other things for this swap apart from: hubs, rotors,
> calipers, trailing arm
original calipers won't fit, Upgrade to ITR calipers and pads.
Same applies when upgrading rear rotors, need new calipers.
Rear upgrades can get fiddly with brakes hoses and hand brake cables.
Everything is here:
http://honda-tech.com/zerothread?id=1811368&page=1
Nick.
PS. 9CLP14S rear calipers are also found on Prelude's. Hint! Hint!. The caliper bracket however is slightly different and currently researching other differences.
PPS. Mini2 rear rotors are 4x100, 64mm ID hub bore. Might be able to get away with just a hub 61mm ID 64mm hub-ring. Will post more when more info is available.
Bookmarks