Disclaimer: The following are provided as a GUIDE ONLY, and neither myself. nor the original writer, nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Aim: Renew look of old or plain looking Valve Cover
Needed:
1 can Primer
1 can VHT Wrinkle Plus Spray Paint
1 800 sand paper
1 400 sand paper
masking tape
Razor
Pilers
10mm spaner
Blow Dryer
Step 1: Removing Valve Cover
Remove all the Blue circled area
Step 2: Sand down metal
Use the 400 sand paper first then 800 sand paper
Step 3: Seal Holes
Use masking tape and cover all holes
i covered the honda sign and letters but u can leave it and sand the paint of later. Up to you
Step 4: Spray Primer
Spray a few times
Wait few minutes after each layer
Try not to over spray it maybe run.
and let it dry for a bit before spraying wrinkle plus
Step 5: Spray VHT Wrinkle Plus
Spray a few times
First vertical then horizontal then diagonal
Step 6: Waiting for paint to dry
You can leave the paint to dry by it self
or use a blow dryer to increase the speed
Step 7: Reinstalling Valve cover
once done u can install the rocket cover back on the engine
just remove all the masking tape and bolt everything back on
If you did put masking tape on the sign and letter you should remove it later.
If you didnt use masking tape you can file it down later.
Then Your done.
Hope DIY help ppl.
Thanks
Bookmarks