Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
AIM: Install HID's in a DC5 Integra
Tools: 10mm 3/8 socket; 3/8 extention bar; 3/8 wratchet; phillips head screw driver; insulation tape
Steps:
Step 1
remove the front bumper bar, the yellew arrows piont to screws that need to be removed, the blue arrows point to clips that need to be removed. to remove these clips lift the center part then pop out the clip.
STEP 2
remove head lamp assembly, remove 4 nuts, see yellow arrows below, disconect the lamps, see red arrows
STEP 3
mount the HID transformer, undo the bolt from the gaurd, mount the transformer.
also run the wires for the HID globe up to the engine bay through the cut out.
STEP 5
Install the HID globe
STEP 6
plug in the transformer power feed from the head light low beam connector, make sure you wrap up the connector with insulation tape, also ensure corect polarity.
final result
do the same for the other side and install your heal lamps and bumper in the revers order you removed them.
I would like to thank Dundas and Jenza for their help with this install
Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!
Reply With Quote
Bookmarks