Euro Lux HID adjustment

[TRaNz]

Hey guys, this may be a nub question but, recently installing the Tein SS, the auto HID leveler was disconnected. Basically not in use anymore.
Now the car is slightly lower at the front, which made teh HID low beam lights seem to point to the ground a bit more.
Just wanted to know how do i make them aim up a little more.
Yeah im missing the days of blinding people jks

Any help would be great.

Cheers.

[Merlin086]

Had the same problem...

There's a small black knob on the rear of the HID cover, you can twist this to adjust, it is a bit tight, or you can put a small screwdriver into the hole next to it to turn the adjustment dial from the inside via the notched wheel.

Just park the car level against a wall and take adjust them up a even amount, remembering to keep the drivers side slightly lower.

[big jim]

You can also disconnect the battery for half an hour then reconnect and self levelers re-learn light position.

[aaronng]

Had the same problem...

There's a small black knob on the rear of the HID cover, you can twist this to adjust, it is a bit tight, or you can put a small screwdriver into the hole next to it to turn the adjustment dial from the inside via the notched wheel.

Just park the car level against a wall and take adjust them up a even amount, remembering to keep the drivers side slightly lower.

Can you take a pic of the adjustment knob and wheel for him? I tried directing him to the hole for adjustment but he says that there is nothing in there.

[aaronng]

You can also disconnect the battery for half an hour then reconnect and self levelers re-learn light position.

No, it doesn't work that way. It doesn't relearn any positions. Anyway his sensor arms are tied up because there isn't a mount point for it on the SS and Ingalls camber kit.

[TRaNz]

yeah is it possible you could put up a pic Merlin? Aaron tried to show me, but i spose im just really really slow/sto0pid..... I really dont want to have to raise the fron of my car, i like it scraping things.

[aaronng]

Remember to replace the missing clip from the undertray. The whole undertray will cost over $200.

[Eddie]

i had an issue where one light is higher than the other
didn't know how to adjust.
apparently in the manual it say there's a HID switch but i can't find it anywhere. does it come with a switch on the 2003 model lux.

i'll keep an eye out for a black switch now hahaha

[aaronng]

No HID level switch on Aus-spec. That is for european-spec Accord Euros.

[Eddie]

So the only way to adjust the light is with that black knob?

[TRaNz]

AAAaaaa, Merlin, where are ya buddy i need assistance with that pic,...LOL

[Merlin086]

AAAaaaa, Merlin, where are ya buddy i need assistance with that pic,...LOL

OK...here's a pic looking to the front of the car on the passenger side, the drivers is a bit harder to get at. Remember, just twist the knob at the back.


I have put a orange sticker on the adjuster to 4 U 2 locate it easy.

Don't forget to have the drivers side a bit lower the way HID's come adjusted from the factory, to save blinding oncomers and having a head-on!

Just don't point them at the trees when u first adjust like I did!..lol