My diy CAI (what pod officer?)

[czy_sol87]

Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!


Aim: CAI
Required: piping, pod filter, plastic weld or epoxi, tool box

hey guys did this a while ago, but just took pics 2day

first step is to take off the bumper and resenator box
heres a link to a diy of what to do for this first step
thanks to Twincam16 http://www.ozhonda.com/forum/showthr...ghlight=delsol

well after all that, the next step is to take off the top of the airbox like so and remove the air filter element


next is to find a pipe that will hold the pod and be conected to the end of the airbox, its up to u what u use,
but i was 'el cheapO' and use a $5 piece of plumbers piping

mount it inside the guard to the end of the airbox like so

use zip ties to hold it in place and so it doesnt move
there is a hole to where the resenator was connected to the airbox

next step is to plastic weld or epoxi the piping to the end of the airbox

took me a while to do this step
i know, i know it looks sh*t, but whos gonna see it

after all that ur done, all u gotta do now is to put the cover back on


and u're end result should look like this

note: pod under head light

now ur done with ur diy CAI u can put back together ur bumper, put away the tools
(very important step) and go for a drive

comments: if i was to do that again i would of painted the piping black to look like
the rest of the intake system, doesnt show much but if u look carefully u can see the white piping