Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor Ozhonda take any responsibility for the outcomes of someone else doing the following. You follow these steps at your own risk!


Aim: Wire tuck left fender
Required: Electrical tape, cable tie, tools! knife!
Steps:alot
Other comments

I recommend that the left side is the easier side to start it off.. so here it is...

I recommend this side as it is thea easiest place to start

Below you need to remove your lights, im sure most know how, i have a different setup as some people..



You will now remove the fender, below marked red are the bolts and some are actually screw. there 10mm bolts ;D



Once i have removed the fender, i took the stock tape of and the tubes and basically have the wires seperated.

- There is grounding thing which has several wires connect to it grounding..
- Wires for the left lights, and indicator
- Wires for the Radiator Fan
- I had wires for my alarm system

What i did was group it up, i had to cut the wired to fit through the stock whole already placed which took awhile. i extended some ground wires so the taping up would be easier



Here is a pic of the grounding plug im talking about which connect all the grounding for lights, fan and some other stuff which i hid under the body of the car (not in fender)



Once done you can now see my result :
PS.. There was 2 wires i extended which was the grounding wire ONLY, others were alarm and fog light based



From Engine Bay to fender.

I basically cabled tied the loom to the boot puller thingo which i habnt had any rattling problems.



Now put it all back up! and it may look like this!




SORRY ABOUT THE QUALITY OF THE PICS!
PS.. currentlyt working on the middle part of the bay.. will post that up as well