k24 eg

**koldfire** · 23-04-2007 08:31 AM

CRV engine == K24A1 block has a lower static compression ratio (9.6) and in my POV it's less optimum for K24/K20 frank motor. Perhaps upgrading to a higher comp. piston like the Accord Euro pistons (10.5) is more suitable for the setup.
IMO, it something worthwhile to look into...

also, u need k20 oil pump, K20 etc etc...

**rawr** · 23-04-2007 10:58 AM

what would the approx cost of a half cut k24 from a euro.. and then the installation into an EK.. and the power stock

**barefootbonzai** · 23-04-2007 11:09 AM

Doing all the work yourself, you'll be looking AT LEAST $10G minimum installed using the cheapest parts, and finding 2nd hand bits yourself.

Doing all the work yourself, using Quality parts AT LEAST $12G installed.

Getting a workshop to do the job, could be anywhere between $12G - $15G+.

It's an expensive root, but if you really want it, this is what it cost.

**rawr** · 23-04-2007 11:13 AM

kk thanks

wanna move to sydney so you can do the conversion if i ever get it done?

**mr_vtec** · 23-04-2007 11:21 AM

hahaha yea all i can say is i dont regret one bit of time spent on my car or money it is the best sleeper lol...
just wish was rich lol...
hahaa
just if some one is doing it to a delsol like me then you will have a rear mount problem as they arnt the same as eg civic rear mount and they all say it is but till they get down and dirty they will figure it out it aint the same so alittle bit of custom work is needed for the rear mount..