Ebay aftermarket headlights

**Gio** · 17-11-2007 12:26 PM

Hey guys i would like to know of anyone that has bought headlights for their civic from the US. Im looking at buying some but im not sure if they will work as i have heard that they wont. Does anyone know if they will fit/work in the aussie civic?

Thanks Chris

ps-This isnt an advertisment

**bankids** · 17-11-2007 12:58 PM

they'll work, and they'll fit, but their design was for american spec which the driver's side is different to here. the only problem is the cut off line of the low beam would be ____/ but here in oz we use the low beam like \______ the little \__ is for lite up the signs beside the road. but the US one will just blind incoming vehicle.

not a big problem. still works.

**Gio** · 17-11-2007 02:32 PM

so if i get them they will be too bright in lowbeam, could i modify them somehow?

**steve88** · 17-11-2007 02:51 PM

you can. ive done my research and i found the halogen globes burn out real quick, and i've heard people rewire hte headlights to stop that happening + the halogen globes to replace are a real slut .thats why i havent changed mine yet

**Gio** · 18-11-2007 11:06 AM

So if i was to buy them from the US what would i have to get done to them to make them connect to the aus civic and be proper??

**ACTI0NMAN-1** · 18-11-2007 11:10 AM

if they are projectors, you will have to oven them and remove the cover. then unscrew the projector lense. pull them appart and flip the internal cutoff plate. then reassemble.

**getm_up** · 18-11-2007 11:55 AM

gio my friends

buy em from aus

**buddah51au** · 18-11-2007 05:24 PM

If you want lights you can't go past a set of Lightforce......good for approx 500 meters on a straight road

**bankids** · 18-11-2007 08:51 PM

if u want to buy from ebay. look for a NZ seller he sells the oz spec ones saves ur oven time..

**Gio** · 20-11-2007 10:32 AM

Thanks for the help guys. Hey get em up! Yeah it will be cheaper from the US but it will take time to mod them, i think ill go wit the NZ ones tbh

**dahon** · 18-01-2008 12:22 PM

just make sure you dont go for the cheaper ones as ive also heard they burn really quickly. as for adjusting the lights, there should be two screws at the back of the light so you can adjust the profile of the light beam to suit a RHD car.
also i think you might have to check if the lights have a park light, because with my projectors i don't and had to use a double contact socket for my signals - 5w for park and 25w for signal. had to splice the active park light cable and rewire it to the low socket of my signals.
Also just make sure the beam hits below the trim, everyone hates those people with the fake HID kits that just produce glare everywhere.