License plate relocator

[XP02ED]

Hey guys just a noob q..

Did you buy your license plate relocator or make it?

i was gna buy one although can't justify the expense as all it is are brackets and screws.

so to any who done a DIY or a bracket, where did you get them from? end result?

I plan to go t bunnings tonight and grab a bracket that will be mounted above the hole.

[SHOGUNOVDDRK]

I think most people DIY them with a drill...

A license plate Relocator isnt too hard to do really...just look at where you want to mount and go to Bunnings and get some shizzle from there

[BiLL|z0r]

Just make sure if it's the rear plate you relocate it has light on it to be legal.

[panda[cRx]]

Just make sure if it's the rear plate you relocate it has light on it to be legal.

while that's true he has an em1 so i don't think he'll touch the rear

[IEVAQ8]

Hey guys just a noob q..

Did you buy your license plate relocator or make it?

i was gna buy one although can't justify the expense as all it is are brackets and screws.

so to any who done a DIY or a bracket, where did you get them from? end result?

I plan to go t bunnings tonight and grab a bracket that will be mounted above the hole.

i got one that iu bought and never used.

pm me if you want it

[MWAKU]

i made a thread on this before, look it up, some useful information there

[simonnowis]

going to a hardware shop and buying the brackets and diy is alot cheaper, i know cusco have one, but they are expensive, correct me if im wrong but i think it was like $200bucks just for a piece of metal.
otherwise if you dont want to drill holes use zipties.

[SHOGUNOVDDRK]

going to a hardware shop and buying the brackets and diy is alot cheaper, i know cusco have one, but they are expensive, correct me if im wrong but i think it was like $200bucks just for a piece of metal.
otherwise if you dont want to drill holes use zipties.

lulz

Or you can go to golo and buy one of those hole punch things use a hammer and tip tie as you please

There are a few people that make them but 100+ for a piece of metal, Siff pay that much!

[XP02ED]

i got one that iu bought and never used.

pm me if you want it

PM'D

well im going to bunnings tmz night to buy alot of stuff anywaiz so ill go look at some brackets if i dont find one at a reasonable price.

if i do get a bracket, ill most probably just use sikaflex.

[ralph_ef9]

just go burning get a piece of aluminum sheep about 2-3mm thick that cost about 20-25 bux,
cut it and bend it urself, u know how to do it, u may need the metal blade to cut it!
i found a pic for ya! It looks like that!

[XP02ED]

hmm yeh thats true, which ones the bottom bit and which ones the one which goes onto the plates

[ralph_ef9]

like this:


i think u can adj it a bit....if u want to put it higher then put it up side down, it all depends urself.