Engine light ON after dash change

[defect]

Hey guys
I just changed my ek1 dash to ek4
and engine light comes on and car doesnt start.

just noticed i ****'d up by removing all the plugs before removing/disconnecting the battary.

what did i fry?

[trism]

checked all fuses?

[na-118]

you should of just disconnected the negative battery terminal first, it should of been fine,
check the main fuses and the little basics to get it starting

[VTec1987]

check all fuses to see if they are ok.
If all good, just disconnect the negative battery terminal for a min or 2. Then try it again

[OMG.JAI xD]

dash or cluster.

if its cluster. check that the cluster actually works.

i disconnected my cluster on and off without battery off with no problems.
make sure you have the connectors around the right way.

you couldnt have blown any fuses.
UNLESS you had ignition on. which would be stupid.
when you try and crank, what happens?
light dims? any clicks or flashes?
if so your battery mightve died in the process. probably had the door opened while doing it, and your interior light was left on.

give us more info.

start off with, what happens when you try to crank.

=]

[na-118]

yeah, you don't know if he blew a fuse, it could be anything triggering this problem, but your right try crancking it first, if it jsut clicks try jump starting it happened to the bike the other just clutch started it was fine,

[trism]

check all fuses to see if they are ok.
If all good, just disconnect the negative battery terminal for a min or 2. Then try it again

they might look fine

you need to change them but

[ECU-MAN]

check all connectors around the passangers side,

chances are the green connector near the ecu is the problem,

[defect]

i disconnected battary for 3m, i did changed the cluster too, but i doubt the cluster is the problem. its plug and play.

ill check all fuses and look around the ecu

prob solved! missed a damn plug