DC Sports Header Flex Pipe Crack-O

**euro77** · 27-11-2006 08:06 PM

LAB = Lower Arm Bar

**Chris_F** · 28-11-2006 07:24 AM

Originally Posted by EuroAccord13

Same here, the LAB will go back in only if the ETD helps reduce the chances of the bar hitting the exhaust...

Only other issue I have with the LAB is my clearance.. I've raised the height of the car three times and the LAB still can't clear many humps even crossing over at an angle....

Yea it sucks aswell because i really felt the steering tighten up with the LAB on. I also had the clearence issues. When i was 10mm higher than i am now i only had 7cm clearance from the lowest point on the bar. 6cm of ground clearance is only about 2 inches, so tahts another hting to consider and my car isn't even that low (2 finger gap all round)

I wonder if a front sway bar would give a similar feeling of a tighter front end?

**TypeG** · 28-11-2006 07:50 AM

omg.... my LAB is coming and i may have trouble fitting them as well coz my car got 1 finger gap all round

**Chris_F** · 28-11-2006 08:03 AM

Originally Posted by TypeG

omg.... my LAB is coming and i may have trouble fitting them as well coz my car got 1 finger gap all round

you should have an ETD on by then though, so that should stop your knocking issues. In terms of ground clearance you'll have 5-6cm, the bar itself extends at least 3-4cm lower

**TypeG** · 28-11-2006 08:19 AM

okay mate
will install ETD on Thurs
let you know in the weekend

**Chris_F** · 28-11-2006 08:34 AM

thanks - I really hope it fits, coz i want my LAB back on

**ALN** · 28-11-2006 05:43 PM

Originally Posted by stephen8512

ive said countless times
"quality speaks for itself"

In some ways, I agree with you, mate.

About the DC sport header, I think it has been discussed in other US forums awhile ago. There are customers found crack on their header and complained to DC sports about it and luckily most of them get replacement but not sure about the SS header though.

**TypeG** · 28-11-2006 08:20 PM

Originally Posted by ALN

In some ways, I agree with you, mate.

About the DC sport header, I think it has been discussed in other US forums awhile ago. There are customers found crack on their header and complained to DC sports about it and luckily most of them get replacement but not sure about the SS header though.

read all the posts first

I totally agree u get what you pay for but this problem is NTH to do with the quality (since we not use DC anyway).

**ALN** · 29-11-2006 09:15 PM

Originally Posted by TypeG

read all the posts first

I totally agree u get what you pay for but this problem is NTH to do with the quality (since we not use DC anyway).

My bad, mate.

Since I assumed if the header is DC one, you guys should probably talk to the seller or the DC sports about it though since there are customers complained about the DC header crack for euro/tsx so it might not be caused by the LAB it self but SS header is different case though.