Results 1 to 12 of 85

Threaded View

  1. #1
    Member Array
    Join Date
    Sep 2003
    Location
    Perth - WESTERN AUSTRALIA
    Car:
    94 Civic EG5 with JDM B16

    JDM B16A swap TROUBLE

    S.O.S.

    just picked up car.. dont ask about the workshop.. is running in Limp Mode thus no vtec and EXTREMELY rich fuel mixture - used 20L in 40Kms !!

    Throttle response is Shocking, with massive hessitation and most of the time stuttering and almost stalling when taking off form a start.

    Obviously running in Limp Mode and with hte fuel mix so rich, the plugs are likely to be fouled by now so I already know that OK..

    is throwing MAP Sensor code, Electronic Load Sensor Code, and Knock Sensor Code.

    I know I havnt wired the Knock Sensor so that's OK, but I cannot locate the MAP sensor as it is different to Aussie EK4 and EJ VtiR Coupe's that have it right on top of the Throttle Body.. I cant find it and I cant see any unused plugs dangling down anywhere, however the wprkshop failed to connect the TPS when I picked up the car..

    WHERE is the MAP sensor on this JDM B16A from 95+ Del-Sol SiR II ??

    FYI my car is 94 Civic VTi SOHC VTEC D16Y1 (OBD1), using my original Firewall-side Harness and using the B16A Engine-side Harness.....

    any other help with wiring advice etc GREATLY appreciated as thanks to the workshop My budget has been blown out of the water...

    Last edited by VTEChnique; 05-09-2004 at 02:29 AM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Powered by vBadvanced CMPS v4.1.3


Terms and Conditions
Ozhonda.com is in no way affiliated with the Honda motor company or Honda Australia in anyway whatsoever.