Sure thing SHOGUNOVDDRK, the case is made out of aluminum sheet, purchased at mitre 10, but probable get the same stuff at bunnings cheaper. it's about a 1.2 meter by 1.2 meter sheet ~1.2mm thick (would use 2mm if they had it). and is worth around ~$20. Also used some small nuts bolts and washers from super cheap auto ~$3 pack
all up case would of set me back around ~$40
Was about 5 hours work all up, using a dremel isnt that fast.. lol the hardest part is the folding.
The case was done in a steel etching primer then silver on the front then the blue all over (inside and out). ( I like spray cans there fun)
the whole in the top will eventually have some acrylic/perspex with ventilation slots or holes.
I Have already started a new case as i'm not 100% happy with this one and think i can do better now i have all the hardware for PC, and can now work out a better size and dimension for the case.. (lower profile mostly, and better mounting for motherboard, hard drive and power supply).
Will try and write a DIY on the weekend if I have time
Reply With Quote
Bookmarks