Mitsubishi GSR injectors in b series

[Weq]

just an update, i got these working, all that was needed doing is to mod the o-rings to suit the fatter GSR injectors, and instead of resistor box, i soldered 10w10ohm resistors to the yellow/black wire (power) on each injector, runs pretty good

all will fit the fuel rails. Some may require small mods to the injector o-rings at the manifold level. All these injectors talked about require a resister box though.

Im going to quote myself to re-inforce the fact i dont talk sh*t like so many ppl on this forum. All that comes outa my mouth is the cold hard truth.