All i can really think of is to cut out some of the softer boot material away so that i can get to the under side, flat surface of the carbon. Then mount on the underside, two rectangular tubes of 3mm or so Alloy (already found them at bunnings) I'm thinking the square tubes because i don't think they will flex barely at all, and will sit up hard against the boots surface.
Mounted with a bolt on the outer sides, as well as the four bolts where the brackets for the wing are. Therefor when the downforce from the wing puts pressure down onto the boot it will spread the weight load across the whole surface of the boot and not just the centre.
Anyone else got any ideas? or suggestions?
Bookmarks