Well after some more/final testing today I can bring to you the first pic of the intake Adrian has been painstakingly working on......



This is still the prototype and the propper one still needs to be finished off.

We did a back-to-back run against the OEM box (the car remained strapped to the dyno the whole time to get figures as comparable as possible) and we saw an increase of a bit over 5% at the wheels. OK so it was only about 4kw or thereabouts, but it's not half bad for what will be a simple bolt-on mod.

A fair amount of dno time went in to getting the length spot-on. It's amazing how much difference 1" in length made.

For all those worried about pods making you lose your low-end...fear not. This setup does not lose out anywhere in the rev range.....

I will post up dyno readings once the final product is ready.....

J