Hi all, i've ran into problems with my ignition, and after changing the coil i still had no spark so i wanted to do the whole rotor and dizzy cap, and change to an external coil while im at it. I've bought a kit which consisted of the MSD blaster 2 coil (which has a female plug for the coil which i have to convert now) and a MSD external coil cap.



Im not running the multispark unit 6AL. The instructions have directions on how to wire up the coil with the multispark unit, or without it i might need to have a resistor in line.

So what im after is does anyone know you actually need to put in an 0.8 Ohm resistor when installing on a d16y1? I read in another thread that there is one built into the cap.

Anyone else install an external coil without the multispark?? I know there is also a SS external coil, not sure if that's different from the blaster 2 coil internally.