Ok so i hit into a problem... im tryna tap a oil pressure sensor, using a sandwich plate, an things turned for the worse..

long story short, i installed it, having the rubber o ring on the block an to the sandwhich plate, an plate to the filter, had the sensor an gauge plugged in an all wired, started it up for 2 seconds, i hear a weird noise, shut the motor asap, an look down an i see oil pissing every where... FML

I dunno what happened, was the sandwich plate not tight enough? Nothing popped off, oil filter was still tight on

I reverted back to oem filter setup with no sandwhich plate as i still need the car to drive... -_-

The motor is fine, nothing wrong the engine still had oil in it, so it didnt starve, lucky!