Thanks guys.

Managed to get enough ali to finish off the cabin thanks Andrew, my buddy from Tripod cars, everything else has come to a grinding halt until business start up again, friggin holidays...
So put major bits of panel in to make the sills, probably the hardest panels on the car to make, mainly because I decided to make them all one curved piece instead of 3 flat panels, to match the tunnel top as well, I think straight panels looked a bit naff in this car.









You can see I'm making the rear 2/3rds of the tunnel top and passenger side removeable, as well as a hatch in the drivers side for future access if needed.

Center tub back on.



Sill area



about 2 hours later at this stage, fettled in pretty well, another hour or 2 tomorrow should see that side done, 1 down and 1 to go!