Finally after months of waiting we finally have some progress!

Both passenger and drivers side mounts have been cut which leaves the rear hang mount to be finalised.

As the picture suggests the engine is going to sit very forward and very low (will be 1-2 inches lower than in picture) for the primary purpose of getting the axles as strait as possible...doesn't hurt weight distrubution either

We've bit the bullet and have opted for custom billet axles which should be started this week... from there the engine bay will be resprayed and cleaned up then its onto ancillaries/wiring/exhaust and tune.

We are hoping to have the car up and running in a month so updates should come thick and fast from now on...