Dual Carb Modifications

[rly1]

I haven't taken out the whole airbox yet,
just took out the lid, one piece of mesh and one of the spacer out to get the correct size when I go around shops.
Chingaling, are you saying that you just cut a piece of foam, stuck it on the 2 piece of mesh and stuck the mesh back on ?
That sounds good but does it shows any improvement ?

[rly1]

Chingaling, would you have any pics of your current setup ?
if so, please post

thanks

[chingaling]

Chingaling, would you have any pics of your current setup ?
if so, please post

thanks

yeh i did that.. and it actually helps coz got my air flow as well .. and plus remember to cut the springs inside the kehien piston thingy cut about 2 - 3 coils

[rly1]

Chingaling, Have you got any pics ? because I wanna see how you got around the whole in the mesh (it is for one of the vacuum tubes)
did you remove the piece with the metal tubes out (right between the 2 carbs throats) ?
thanks

[rly1]

Chingaling, Ignore my last post. The metal tube sticks out from the throats, through the spacers and through the mesh, can you show me how you did your setup to accomodate that metal tube ?
thanks

[chingaling]

Chingaling, Ignore my last post. The metal tube sticks out from the throats, through the spacers and through the mesh, can you show me how you did your setup to accomodate that metal tube ?
thanks

alright i will take a pic after my assignement :P

[rly1]

thanks, I'll be waiting for your pic

[rly1]

Chingaling, any updates for the pics ?
thanks

[chingaling]

sorry its not clear at all.. but u see the filter right below the BIG TORCH ? thats the one im talking about

[rly1]

Thanks Chingaling, I get the idea but I'm just worried that the piece of foam might get sucked in if it's not attached properly.
did you use any glue or anything ?

[chingaling]

Thanks Chingaling, I get the idea but I'm just worried that the piece of foam might get sucked in if it's not attached properly.
did you use any glue or anything ?

it wont bro.. the foam is sitting on the top of the MASH bit.. so it wont go in.. and CARBY dont suck air that strong.. so is ok

[89civic]

it wont bro.. the foam is sitting on the top of the MASH bit.. so it wont go in.. and CARBY dont suck air that strong.. so is ok

hey. did u just get the unifilter foam covers and make your own size? did u put it between the spacer and the gold metal cover? did it make improvements? and do u suck to much hot air in? i went up the street with no filterbox lid with no filter and it didnt make a difference