Quote Originally Posted by dyljoy View Post
ok, i will try it later, thx
Btw oops, I just realised my grammar/punctuation made it ambiguous.

1. Cut mesh bigger than the template/original crappy mesh; and then trim to fit the screwholes or cable tie slits (depending on which replica grille you have)

2. Use either screws/washers or cable ties (again depending on which replica grille you have) to attach the mesh and THEN trim the mesh to fit.

3. After using the screws or 'pop-in' screws (again depending on which replica grille you have) to fit the grille to the front; make sure it fits snug.

4. THEN take it out, and use 3 or 5 strips of double-sided 3M foam sticky tape along the bottom part of the grille (ie. the part which sits on top of the bumper) and then it'll hold it in really firmly.

Some of the replica grilles (in my case, the crappy silver one) have a 4th screw/hole for you to use to affix the grille which might make Step 4 not necessary since it'll be stronger; but I personally never used it since I didn't like the silver grille enough to try to get it to fit. The double sided tape is much better.

Hope this helps

PS. When I saw the Mugen wing in person.. it's huge. I'm guessing it's the same size as the Evo or STi ones but can't really make that much of a comparison. On a sidenote, in Malaysia I saw a replica one and it was around RM350 from memory; or about $120aud.