If i can remember correct ( I'm getting old )
On a front wheel drive car you should not change the offset of your wheels from standard
I think the offset for honda integra is 45 ( please correct if wrong)
....its illegal for starters .(that doesnt stop some of us)
....it also affects the handling in a bad way
^^^
but because original wheels are 5.5" wide thats why the offset is 45
now hes goin from 5.5" to a 6" wide the offset needs to be lower or else the wheels ill pump out of the guards
^^^
but because original wheels are 5.5" wide thats why the offset is 45
now hes goin from 5.5" to a 6" wide the offset needs to be lower or else the wheels ill pump out of the guards
its possible to run up to 7 inch wide rim with 215 tyre with 45 offset and no rubbing ....no need to change the offset
Will this size rim fit a dc2r with no clearance issues
What wheels are they? The wheels will clear the extremitys no problems. But you also need to make sure they clear you calipers. Best bet is to fit them and make sure they clear.
Originally Posted by teaseR
i was told that 16x7 +38 would sit nice under the guards
Maybe, but thats pushing it I think. I have 16x7, +40, 205 tyres on my DC2R. Front is no problems, but my rear tyres are extreemly close to the lip of the guards, no rubbing at all.
Originally Posted by b20b
its possible to run up to 7 inch wide rim with 215 tyre with 45 offset and no rubbing
^^^
but because original wheels are 5.5" wide thats why the offset is 45
now hes goin from 5.5" to a 6" wide the offset needs to be lower or else the wheels ill pump out of the guards
dude...you are aware that lower offset increases the track right? so if you really want to maintain the same track as before but use a wider wheel then the offset has to increase.
Reply With Quote
Originally Posted by teaseR
Bookmarks