Aftermarket Headunit

[dc]

aka nsx, where abouts did u run the wires through the firewall? near the battery where two pipes run thru the gromment? or nearer the driver side where the relayed power goes thru? i tried the latter but i couldnt make the grommet budge! any tips?

[aka_NSX]

honestly i can't remember which side but usually i run the cable the one that close to the battery, and the grommet its a little bit hard to push you need something very pointy, remember if you make the grommet bigger DON'T FORGET to put silicone otherwise water might go in . . . . .

[dc]

i just ran it thru the hole on the driver side where the fused power goes in. Im not too worried abt water goin in...cos if there were *that* much water in the engine bay id be in trouble anyway...but the grommet does keep out a lot of engine noise. moral of the story: ghetto way of hearing more engine/ pretend-induction noise is to remove the grommet.