Door trims are painful for first timers.
But its not that hard. I can do it in 5 minutes per door trim.
So, first things. Take off the two screws (in the door handle pocket area and behind the inner door latch). Pretty obvious.
Then take of the triangle cover at the top front corner. There are two clips, just pull firmly.
There will be clips holding the trim onto the door. start from the top front corner, run ur hand down between the door frame and trim. the door trim will start to pop out. go all the way around the door trim.
Next u will need to detach the door opening mechanism from the inner door handle. so u pull the inner door latch unit free from the actual trim. you will find its connected to a metal wire thing. detach that from the inner handle.
then u lift the door trim up and its off!
have a play, its fun.
As for wiring the fronts, i just snipped the factory clips and used spade connectors (Male/Female) from factory cable to speaker.
Same goes for the rear. Took me around 30 minutes to wire all the speakers to factory speaker cable. Jsut get ur +tives and -tives right. No need to professional electircian.
diagram
honda speaker cable + tive ---- > 'plug' > ----- +tive MTX speaker cable -> +tive speaker terminal
honda speaker cable - tive ---- > 'plug' > ----- -tive MTX speaker cable -> -tive speaker terminal
sounds 10x better than stocfk speakers. But wait till u get an aftermarker headunit. its 10x better again.
Reply With Quote
Bookmarks