Quote Originally Posted by Omotesando View Post
Well I have the report for the wheel alignment - pre and after.

From the aligntment specs (which I wont retype here as its too cold to go outside to fetch it), it should be tracking straight on.

Now it is pulling to the left.

I think the RE040s tramline worst, that one I could make an association with.

However, other problems such as bump steer and not tracking straight or being really darty AREN'T exclusively restricted to RE040s.

Tramlining doesnt cause problems nor will cause any accidents.

Car not tracking straight or swerving all over the place whenever the camber is uneven or there are pot holes will and I still dont understand how people can blame this on the RE040s fully. The only problem with the RE040 that I had was tramlining but that was only a small part of the whole problem.

I have had my sub frame adjusted when I had REO40's, pulling only under camber now, excessively after adjustment.

Now I have new tyres same thing !! NO DIFFERENCE

Going to get my sub frame straightened only then will this rule out REO40's

Does that make sense?

Not trying to knock REO40's, not saying they good either just process of elimination, has to be proven beyond doubt.