Disclaimer: The following is provided as a GUIDE ONLY, and neither myself nor OzHonda take any responsibility for the outcomes of someone else doing the following.
Well we all know about the stupid f'ked up P laws intro'ed onto Sydney P Plate drivers at the beginning of this month and also seeing my 3rd Gen Lude has absolutely no place to put these damn clunky P Plates I went hunting...
- P Plate Holding Brackets - Nope can't fit em' onto my 3rd gen Lude...
- Sticky Tape... Too Ugly...
- Lodging them between the numberplate and the car - Warped my damn # Plate
Anyway So I figured I'd wire them onto my car...
First step is to get some wire. I went to bunnings for this. 1.85mm Thick.
Next is to make 2 holes on either edge of the Plate.
The 3rd step is a little bit different for everyone. You should be able to find somewhere you can twist and latch the wire onto on your car. This is how I did mine. (For the Rear I hooked it up to a toe bar that was already on the car when i bought it)
Rear
Front
Bookmarks