DA9 interchangeable parts

[ACTI0NMAN-1]

i so wish i got b1c8c or something rather than building my b18a :\

Chuck nitrous on it then, you've built the engine.

[crispy]

Yes, but is his engine capable of handling nitrous? Plus there is nothing wrong with a bit of non-vtec power, i would much rather have a killer b18a then a balls stock vtec, its much more sleeper

[180sx]

B18a are fun to drive, i enjoy to drive my friend's DA (clint's) more than my own one, B16a IS NOT good for daily drive

[180sx]

Yes, but is his engine capable of handling nitrous? Plus there is nothing wrong with a bit of non-vtec power, i would much rather have a killer b18a then a balls stock vtec, its much more sleeper

100% agree with this dude ^^

[Spoon DA9R]

Yes, but is his engine capable of handling nitrous? Plus there is nothing wrong with a bit of non-vtec power, i would much rather have a killer b18a then a balls stock vtec, its much more sleeper

erm...and suggestion on mods?

i still miss my old b16a DA...bloody commodore drivers..so many car on the streets and he have to smash mine..

[180sx]

erm...and suggestion on mods?

i still miss my old b16a DA...bloody commodore drivers..so many car on the streets and he have to smash mine..

TODA VTEC KILLER kit with ITB

[Spoon DA9R]

then cant drive on street?

[180sx]

^^ anything can be driven on street

[Spoon DA9R]

back to the topic...just fitted spoon mirrors...pain in the ass though...as quoted by my friend who's done it already " u r gonna need to do quite a bit of drilling..."

[tseesinngwailo]

So Far..

I have put the following in my DA9

B16a (complete half cut)
Type R front calipers
Type R brake booster and master cylinder (need brake line re-flare)
EK Koni Yellows (rear) but i lathed down the bushes, EK rear arms do not fit, seem too long (can anyone confirm??)
EG Lower strut brace (aftermarket, but i guess dimensions are same)

What I want to know, does any EG, EK or DC2 exhaust (catback) fit as long as you bring the tip out on the drivers side??? I already have a Tanabe (EX EK) muffler that has been setup on the drivers side, but want to know if the catback from something else would still be same length up to where it goes over the rear control arm ?

Thanks, Chris

[Spoon DA9R]

yes it fit..i was using dc2r BC spec2 before, eg or ek will be too short...

i just got my master cylinder done last week too...gonna look for my gd old spoon calipers again...shouldn't have sold it back then.....honestly most thing fits...from eg or dc2...just that some needs minor adjustments

[[T][L]]

will IACV from the b18c fit on to b18a?