Thanks for the post KenL, all great suggestions!! Don't worry about it being long, detail is good!

I just went and had a look at the parcel shelf, and you're right, there's actually a bit of a cavitity up under there that should fit the PDX nicely. I also see the 4 keyhole shaped slots you're talking about.

Also looking at the boot liner (I haven't pulled it all out yet), and you're right again, it's not that "tight" against the car body, so hopefully there's a spot there somewhere each side I can hide away the x-overs. I'm much more liking this idea than mounting the amp and x-overs to the back of the seat.

Any suggestions for grounding locations for the amp.?

Aside, I was Dynamat'ing my front doors this arvo and noticed a bit of a problem in the drivers side door. Where the wires route through from the car into the door (through the rubber thing); instead of the wires just going through a hole in the door, they go through what looks like a huge plug/socket. It's a little hard to describe, i'll take a photo tomorrow and post. But essentially, I can't see any easy way of routing my speaker wires There problem doesn't exist on the passenger side. Anyone got any ideas?

Thanks again KenL for the great post.

Cheers,
Steve