TEINS for dc2r!

[dslt]

Hey guys, just recently put on a set of teins ha's on my dc2r wonderful ride, but i wanted the back to sit alot lower than it is. The rear tyre is about 2cm from the guards, i had a look at it this afternoon and relised this was the lowest it could go. Just wondering what sussy setup can i get to really dump it?

Cheers guys

[DLO01]

Teins don't alow your to 'totally' dump your ride. You should have looked in to it before purchace.

I have the same Tiens in my dc2r and my tyres are just marginally under the guards at the lowest setting. So if you have a 2cm gap, I don't know whats going on.

[dslt]

yeah maybe i have the gap cause the tyrse are bald, im looking into replacing them this week. Hopefully reduce the gap =)

[DLO01]

What size wheels and tyres are you currently running?

[dslt]

jdm dc2r 15 inch 205 /50

[jords]

aren't the jdm wheels 16 inch?

[Kazaf]

aren't the jdm wheels 16 inch?

That's 98'.
Maybe he has 96' spec JDM DC2

[ricki_kalsi]

Why buy exxy coilovers just to DUMP your car.

Btw... front should be slightly lower than rear.

Also, don't forget that the sussy will sag after a few thousand km's. It will get lower, and the ride will become harder.

[Saget]

Can I ask how much of an improvement have you seen over the stock setup, handling wise that is?

[ricki_kalsi]

Can I ask how much of an improvement have you seen over the stock setup, handling wise that is?

I would guess less of an improvment, if the car hasn't been corner weight balenced.

[dslt]

Pretty bumpy ride, Sometimes its so bumpy that i think it skips a lil over bumps.
I prefer stock ride but i wanted to lower the car, i previously had apexi springs =)