Hey guys
In my Suspension build i have included, Skunk 2 Rear and Skunk 2 Pro series Plus Front Camber kit. I have never used nor setup any sort of camber kit before.
Basically Can anyone give me any recommendations or advice when setting up these F and R kits. Do you simply do it by Eye? or is calculated somehow?
What are Pros and cons to different camber setups? Negative... Zero camber etc. Do i have to unbolt the knuckle from the Front upper controll arm to adjust ?
Also would i need a full wheel allignment before i setup the camber? or after? or doesnt matter?
Once i setup, do i have to drive the car so the camber resets or will it just sit as per normal on ground level.
Any advice is much appreciated
Regards Lyle
Bookmarks