Excellent write up dude!
You beat my to it though - I was half way through writing an identical DIY.
I did mine the exact same way, but I used a light smear of silicone around where the gasket presses onto the light casing just to keep the gasket held to the casing a little better and hopefully keep a good seal after the foam loses its 'spring'.
Tip to others: If you plan on doing the EK9 Taillight mod, now is the time to do it! So you can cut the gasket to suit and not have to go and take it off again when you get around to doing the mod, as there's a possibility of damaging your nice new gasket.
+Rep!
Reply With Quote
Bookmarks