GReddy Kit + D16Y1 SOHC VTec E-manage Untuned = 97.5WKW Not Bad!!

**Lukezen27** · 12-03-2008 05:30 PM

Originally Posted by Weq

Continue to ignore my advice. Its you wallet, not mine!

I've asked Hannys to do 75 but not sure if they will..

They are giving my warranty on the work even though I'm boosted so I can't complain

**Weq** · 12-03-2008 07:05 PM

Originally Posted by Lukezen27

I've asked Hannys to do 75 but not sure if they will..

They are giving my warranty on the work even though I'm boosted so I can't complain

I look forward to the results. I used moly lube and arps recomended 65ftlbs first go. that sh*t didnt even last the end of the block. Nothing beats the seal of a 100,000km old baked on headgasket. If toda is behind your tune, the reason why you gasket failed so quickly was because the last rebuild (whoever did that) was done incorrectly.

**Lukezen27** · 12-03-2008 07:10 PM

Originally Posted by Weq

I look forward to the results. I used moly lube and arps recomended 65ftlbs first go. that sh*t didnt even last the end of the block. Nothing beats the seal of a 100,000km old baked on headgasket. If toda is behind your tune, the reason why you gasket failed so quickly was because the last rebuild (whoever did that) was done incorrectly.

Hannys did the rebuild last time too but that’s not why it failed..

My thermostat died in the middle of peak hour traffic about a year and a half ago and there was nothing I could do but let her overheat and she pushed all the water out...