EP3 Type R

[sai_ANN]

i got mine here through this guy, quick postage as well.

http://www.mrgaiter.com/index.php?ac...&productId=238

sounds familiar...i've got a feeling that i got it from this company too...but off ebay...

did you have any trouble fitting it?

[ekhybrid]

what is ur location

[typercivic]

sounds familiar...i've got a feeling that i got it from this company too...but off ebay...

did you have any trouble fitting it?

yeh he sells them on ebay as well so most likely same guy.

mine was a huge pain as the gaiter was way too long and big so after a lot of messing around had to cut it off at the top and fold in if it makes sense.

will get a photo up of how i did it and what it looks like as had a few ppl as for that.

how did you go with fitting yours? how did you do it so the top bit stays in under the chrome little round piece?

[typercivic]

8a8y8, did you have to take off the plastic trim or cut it for the rear cusco brace to fit? i'm assuming it's the brace that goes behind rear seats in the boot.

[8a8y8]

8a8y8, did you have to take off the plastic trim or cut it for the rear cusco brace to fit? i'm assuming it's the brace that goes behind rear seats in the boot.

take off the plastic trim

im in sydney

[sai_ANN]

yeh he sells them on ebay as well so most likely same guy.

mine was a huge pain as the gaiter was way too long and big so after a lot of messing around had to cut it off at the top and fold in if it makes sense.

will get a photo up of how i did it and what it looks like as had a few ppl as for that.

how did you go with fitting yours? how did you do it so the top bit stays in under the chrome little round piece?

most probably...lol..

i had a few issues as well...in my case it was a of a tight fit around the black bit...ended up heating the leather to stretch it over the black bit and also snipped little holes at the edge to hook onto the bits on the black bit so it has no chance of slipping off...

as for the top bit...the multi-purpose uses of cable ties come in handy...lol...basically the silver bit always stays next to the knob...

[Philip Lee]

and what method did you guys and girls used to take that plastic trim off the dash to do the boot??

thanks in advance.

[typercivic]

i can do a little d.i.y with pics for everyone on my gear boot and how to take of the dash and plastic trim if you want as had to do it to put fm expander on for stereo as well as boot.

basically, there are 3 clips, one at the bottom, top right and top left of the bottom section but pull out the bottom first then right and left but left one is a pain as pretty tough to get out as you don't want to break the clip.

[Nepolian]

and what method did you guys and girls used to take that plastic trim off the dash to do the boot??

thanks in advance.

Phil, you can use the "Two finger in the boot and pull" method, as seen in many old Chinese Shaolin movies

[sai_ANN]

Phil, you can use the "Two finger in the boot and pull" method, as seen in many old Chinese Shaolin movies

LOL...that's right...just be careful to be gentle otherwise you can break the clips... (no...i didn't do that...)

[Philip Lee]

Phil, you can use the "Two finger in the boot and pull" method, as seen in many old Chinese Shaolin movies

lol hahaha

[Frost_FD]

TyperCivic

was that you driving yesterday around 5pm on wellington st?
If so i saw your car