Dedicated DA9 Q & A thread

[thescotty]

would a set of extractors for a Honda Integra late 93 to 2000 model fit the Da integra? and wat would u have to do to make it fit? just flange change or would it not fit the head either? cheers

[sleeper]

depends mate! b series headers all fit each other but the type r tegs have larger inlets/oulets and supposibily the flanges aswell =) vti-rs are the same as da9s i think no one quote me on this =)

[thescotty]

hmm so aslong as its not for the type r it should be fine and all needed would be flange change and angle? sweet

[EKVTIR-T]

fit should be fine but the cat flange might be the wrong angle.
see how at the end there is a flange with a hole either side.
some models the holes are at different angles

[ACTI0NMAN-1]

depends mate! b series headers all fit each other but the type r tegs have larger inlets/oulets and supposibily the flanges aswell =) vti-rs are the same as da9s i think no one quote me on this =)

this is not true, different b series have different size oilpans.
Its not uncommon for a header that fits on a b16a to be to short to fit on a b18a. i know from experience.

[A-man]

has anyone played with scissor doors u can buy off ebay "bolt on" for a da9???

im considering buying them just for the obvious hand horsepower

[thescotty]

dont ruin the DA

[wkdteg]

yeah dude... u should know better than that!

[Spoon DA9R]

well i did something rice on my car today...

[EKVTIR-T]

^ Adam I'm never talking to you again lol

[wkdteg]

fairy lights only look good on the R8

[exodus]

wire wont need to be re done just purchase a conversion harness from obdo ecu to whatever the jdm b18cr is, and will have to use stock da9 drive shafts? engine mounts are fine.

i did a b18c conversion. make sure who ever does the job knows about honda's and sticks to the quote price

correct me if im wrong,

So that means if i don't wanna re do the wiring i just need to purchase a conversion harness from OBDO ecu or for OBDO ecu? So Da9 drive shafts shd be able to fit into the b18CR rite?

another question... our da9 gearbox are using cable whereas the b18cR gearbox is using hydraulic... would i face any problem on later stage if i put in the b18cR gearbox onto a da9?!

Worried