Quote Originally Posted by Riviera View Post
instead of twisting and heat shrinking...

try connector blocks 2 screws one in either side
put one wire in one side tighten it up one wire in the other side tighten that up...
u can cut em up

http://www.marinemegastore.com/image...l/ECS_3170.JPG

easy...

but these are not the BEST options to wire up a headunit
the BEST option is always to solder and either heatshrink or insulation tape
theres nothing better... no chance of it shorting out if it falls out of the
connector block or slips out of the heatshrink when twisted together...

up to you

i soldered and insul taped mine...
solder isnt always the answer,theres nothing wrong with a good compression joint either,the military prefer compression jointing techniques in most of there electrical equipment