Tein SS vs Tein Flex

[ek4-guy]

My mono flex are ek9 ones, I do see the numbers now but i just left them how they come from the factory as the springs where just captured snugly.

I did measure from the tops plate to the adjusting nut and they where the same. Then i measured from that spring capture nut to the height adjustment nut made them all the same installed them and the car sits dead flat

[aaronng]

My mono flex are ek9 ones, I do see the numbers now but i just left them how they come from the factory as the springs where just captured snugly.

I did measure from the tops plate to the adjusting nut and they where the same. Then i measured from that spring capture nut to the height adjustment nut made them all the same installed them and the car sits dead flat

Did you check your monoflex that measurement A in the manual, the height from the lower spring perch to the lower mount is 159mm for the front and 205mm for the rear? Sometimes the assembly worker might be cross-eyed.... If you did, then your preload should be correct.